Title: Using Gerber Omega with Allen DirectCut Cutter Driver
Abstract: Improved cut quality can be obtained with our rubber cutter (model 536) than with the Omega’s GSPPLOT. Install Allen cutter driver and use print from omega instead of output all/select.
Last Update 4-28-6

Title: Using Gerber Omega 1.56 with Allen Printer Driver
Abstract: These program have 16-bit graphics drivers and the Allen Datagraph Cutter driver is a 32-bit driver. This difference in technology requires some care in getting the two programs to work together.
Last update 6-16-4

Title: Tiling fix for Gerber Omega
Abstract: The Gerber Omega program does not send the correct HPGL commands when sending a plot that contains tiling. A change in the gsp.ini and device.ini file is required to make the Gerber software work correctly. New firmware and gerber language is also required.
Last update 5-3-4

Title: Tiling Fix Program for Gerber Omega
Abstract: This program edits the c:\windows\gsp.ini file to fix the Output to Allen Datagraph Cutters so it works correctly for tiling. The program also allows adding cutters on LPT ports and supports the entire line of Allen Datagraph Cutters.
Last Update 8-18-4

Title: Using Smart Mark Option with Gerber Omega and gspplot
Title: Using Smart Mark Option with Gerber Omega and printer driver
Abstract: This TSB describes the procedure to create artwork and outlines to create labels and contour cut them using the Gerber Edge and an Allen Datagraph 315 Cutter.
Last Update 6-22-4

Title: Using Quicksand with Gerber Omega
Abstract: This TSB describes the procedure to use Gerber Omega to create image areas for the Quicksand.
Last Update 6-15-5